The Spa-Swing

Raising and lowering the hammock controls your comfort and body temperature whether sitting up-right or laying in a flat position. Flexibly designed to fit all types of spas by being adjustable from 6'3" to 12'. Made of polypropylene and nylon materials for a long life.

Being completely adjustable makes it more comfortable than any spa's lounge seat.

Whether sitting upright or laying flat, the Spa-Swing allows you to be totally relaxed in your spa. Suspending you in your spa, it easily adjusts so you can lower yourself to the depth that allows you to maximize the full benefit of the jets and bubbles. You can raise the hammock as you get hotter to control your body temperature.

Available in 2 ft. and 4 ft. width, it's designed to fit all types of tubs and adjusts to span spas from 6' 3" to 12' across. Installs easily within 15 minutes.

Easily attaches to any portable / self-contained spa.

SORRY, TEMPORARILY UNAVAILABLE

The 4' Two Person

This hammock is designed for one or two people and operates the same as the two ft. Spa Swing.

Important:
Do not leave children unattended at anytime during spa use!!

SORRY, TEMPORARILY UNAVAILABLE

The Hook The decorative chrome hook is designed to be safe and easy to install. Its low profile and smooth round edges make it very safe and strong.	The Straps The loops on the end of the straps allow The Spa-Swing to unhook in seconds when not in use. Adjusting the depth of the hammock is as easy as pulling on the adjustment straps to raise it and releasing the levers to lower it.

Add a pillow for more comfort!

These spa pillows are molded from closed-cell, vinyl coated foam and are easy to clean. . They feature a contoured form that highlights a sleek, one-piece design. Spa pillows are available in five colors and come with a weighted strap to hold them in place. They measure approx. 9" long by 6" wide by 3" thick.

Installation / Owners Manual

Includes

12ea 1 "x 48 panhead screws
12ea. 1-1/2" #8 panhead screws
4ea. chrome hooks
2ea. PVC spreader bar and pillow support
1ea. hammock

Precautions and warnings

No one under 18 should use this without adult supervision.
Do not use as a floatation device for children or non swimmers.
Do not use out of water.
Do not fall asleep in hammock.
Do not leave Hammock or Spa unattended when Children are present.
Do not jump on hammock.

Installation of 24" one person hammock

Determine the location of the hammock. It is recommended that you put the 24" Hammock in the middle and parallel too but not overlapping a lounge seat if you have one. After finding the location, mark the centerline of the hammock (Fig.2) on the edge of the tub.

Locate the best spot to attach the anchor hooks (14). Then decide if that spot is structurally sound. If not, reinforce with backing (like plywood.) Make sure there are no wires or plumbing behind the anchor points then choose the screw length that fits the best (1" or 1-1/2".) Anchor two of the hooks 21" - 23" apart on center. Or measuring from your centerline mark, measure out 10-1/2" to 11-1/2" each side of your centerline mark. Repeat this on the opposite side of tub. Use the twelve screws you choose, and then discard the remaining twelve.

Install one of the white PVC spreader bar and pillow support (32) in one end of the hammock by weaving it through the net. Then insert the strap (18) into the slot on both ends. This will be the head end or pillow end. At the foot end leave the PVC out and use the hammock without it. This allows the net to relax more for your feet and legs to hang out Then to stretch the hammock tight you can put the other PVC in to help spread the hammock tight and suspend you at the surface.

Now you are ready to hook your hammock to the hooks. Make sure you have it right side up so that the adjustment tabs (22) are up. Adjust loop strap (20) for proper length so the buckle (22) is easily reached for adjustment when using the hammock.

Installation of 48" two person hammock

Determine the location of the hammock. It is recommended that you put the 48" hammock in the center or off to one side but not overlapping a lounge seat if you have one Or if you already have a 24" hammock you will use the outside set of hooks from that, and there for you will only need two more hooks. After finding the location, mark the centerline of the hammock (Fig 2) on the edge of the tub.

Locate the best spot to attach the anchor hooks (14). Then decide if that spot is structurally sound If not, reinforce with backing (like plywood.) Make sure there are no wires or plumbing behind the anchor points then choose the screw length that fits the best (1" or 1-1/2".) Anchor two of the hooks 46" - 48" apart on center Or measuring from your center line mark, measure out 23" to 24" each side of your center line mark. Repeat this on the opposite side of the tub Use the twelve screws you choose then discard the remaining twelve.

Install one of the white PVC spreader bar and pill support (32) in one end of the hammock by weaving it through the net. Then insert the strap (18) into the slot on both ends. This will be the head end or pillow end. At the foot end leave the PVC out and use the hammock without it. This allows the net to relax more for your feet and legs to hang out. Then to stretch the hammock tight you can put the other PVC in to help spread the hammock tighter and suspend you at the surface.

Now you are ready to hook your hammock to the hooks. Make sure you have it right side up so that the adjustment tabs (22) are up. Adjust loop strap (20) for proper length so the buckle (22) is easily reached for adjustment when using the hammock.

Figure #1

Figure #2

Figure #3

Care and maintenance

Do not leave the Hammock in the Spa when not in use.

Do not leave in sunlight when not in use

Rinse with mesh water when done using (when practical.)

Hang to dry after every use.

Find a place protected from the sun to hang it alter every use

Keep sharp objects away from hammock as they can cause damage. If damaged please discard

Do not jump on hammock

Tips and suggestions on use

The pillow support bar (32) should be located about 3 or 4 inches from the edge of the tub so the pillow can rest on the tub and the bar.

Try adjusting the hammock to allot of different positions. You can sit in it like a chair with it lowered or tightened you can even lay on your side.

As you start to get too hot in the spa, instead of sitting up on the side stretch the hammock tight so that your upper torso is out of the water. This is how you control your body temperature and stay in and enjoy the jets, bubbles and water.

Check anchor screws occasionally as they have tendency to loosen after time.

Limited Warranty

The Manufacturer warrants its goods to be free from defects in materials and workmanship under normal use. For one year from date of purchase to the original owner. Should your Hammock fail return it to DLP Industies. We will repair or replace it free of charge.

Warranty is void if your Spa Swing has been damaged through misuse.

Return to
Miscellaneous Accessories , Store Directory

Store Directory | Home Page