|
Step 1: Center the cover on the top of the hot tub so it is even on all four sides. The center support bar has to be adjusted 1-1/2" in from the center hinge of the cover |
 |
Step 2: Each piece of Velcro should be placed approxamately 1/4 of the way in from the edge of the cover (e.g for an 8' cover place the velcro 2' from the edge). The Velcro holds the two Cover Support T's in place. Note: To permanently apply the Velcro, use silicone or "Crazy Glue" (not supplied) |
Step 3: Thread the strap through the buckle as shown. Repeat for other strap. |
|
 |
 |
| Parts List:
|
Let's Check:
|
All the weight of the cover should be resting on your newlty installer Cover Saver. If it is... |
|
...Your Cover Saver is properly installed |
|
When the cover
lifter is in the upright position the cover should not be resting on the cover lifter
center bar.