Other Usefull Pages
[ BBS FAQ ] [ Error Codes ] [ Chlorine Info ] [ Bromine Info ] [ TDS ] [ pH Explained ] [ Electric Heater Guide ] [ Voltage Testing ] [ Pump Air Lock ] [ Owners Manuals ]

Ask 'Dr. Spa' Q & A Message Board



[FAQ] [Help / Info / Guidelines] [Spa Reviews] [Dealer Reviews] [Home Page] [Online Store]
Re: Caldera Error
In Response To: Re: Caldera Error ()

: First, ensure that the circ pump and associated lines are not frozen.
: Then shut down the power briefly. Re-start the tub and see if the
: circ pump turns on and flows water. This condition may be caused by
: sensor problems, circ pump problems or pressure switch problems. If
: you can get it restarted and it will run for a few hours and heat to
: set temperature before triggering the dashes, you can bet on a bad
: pressure switch as the likely culprit.

: John

I did get cold here and I have restarted and was able to get the temp. back up to 103. So how do I check the pressure switch?
Ernie

Messages In This Thread

Home Page , Wooden Hot Tubs , Japanese Ofuros , Hot Tub & Spa Covers
Info & Help , Hot Tub FAQ , Hot Tub Picture Gallery , Virtual Store

PLEASE NOTE: We are Roberts Hot Tubs Inc. (manufacturers of traditional wooden hot tubs)! If you found this webpage through a search engine while searching for a different brand of spa, we are not them! We simply appeared in your search due to that name being talked about on this particular web page. The phone number below will reach Roberts Hot Tubs, not the manufacturer of the brand of spa you're searching for. This is a public forum and you're more than welcome to post a question asking for contact or other information for a particular brand of spa. Almost certainly someone will be able to assist you.
(510) 234-7920
Register with our confidential mailing
list to receive notices of updates, special
offers and free information.
E-Mail address: 
subscribe unsubscribe