Other Usefull Pages
[ BBS FAQ ] [ Error Codes ] [ Chlorine Info ] [ Bromine Info ] [ TDS ] [ pH Explained ] [ Electric Heater Guide ] [ Voltage Testing ] [ Pump Air Lock ] [ Owners Manuals ]

Ask 'Dr. Spa' Q & A Message Board




Re: Softub Impeller, Shaft Seal and O-Ring parts

Hey Mike,
thx for the replay. YES I knew that the Impeller item of ebay would fit. I mean it does have a Softub #.
Well what I am looking for is CHEAPER PUMP REPLACEMENTS which fit also the Softub pumps.
I have a feeling that those pumps replacements parts are availible on different websites such as aqua-man only 50-70% OFF.
Just trying to help out people which do have also problems finding those replacement parts online

It really sucks because I already ordered 3 seals in case I need them + Impeller 1HP & 1,5 HP + Volute Back & Front.
I should have messured before I ordered. I still think those parts might fit, at least the impellers + Volute Back & Front I ordered.
Once I receive them I will let you know if those fit or not.

I always thought the VICO - Ultra Flo Pump replacement parts on this website would fit my Softub pump P-15 pack!
http://www.aqua-man.com/schematic.asp?kc=S1937

Do you think the following link schematic are the replacement parts for the newer digital packs, or not?
Replacement Parts for the Flo-Master - "FMCP" Series Pump by Aqua-Flo
http://www.aqua-man.com/schematic.asp?kc=S871

Is there any way to figure out how much HP my Softub pump unit has?

Thank you very much
Sonntagskind3

----------------------------------------------------------------------------------

I have attached a picture I made for the parts on the Schematic from www.aqua-man.com
which I do think might fit the Softub P-15 (VICO-UltraFlo) and P-25 (Aqua-Flo - FloMaster) units.

Is there anybody out there who tried these parts yet to replace SOFTUB pumps parts?

: I was impressed with your level of research. Here is what I have found:
: Softub seems to have had Vico make this pump for them, as it has a
: smaller shaft than comparable models. The shaft is 5/8", where
: most others are 3/4". Therefore, a PS-2136 seal does not fit,
: and most other non-Softub over-the-counter Vico parts. The parts you
: mention here:

: are the correct parts, correct impeller is 9091200, so the ebay impeller
: should fit.
: Hope this helps!
: Mike

: :
: :
: :

Messages In This Thread


Home Page , Wooden Hot Tubs , Japanese Ofuros , Hot Tub & Spa Covers
Info & Help , Hot Tub FAQ , Hot Tub Picture Gallery , Virtual Store

PLEASE NOTE: We are Roberts Hot Tubs Inc. (manufacturers of traditional wooden hot tubs)! If you found this webpage through a search engine while searching for a different brand of spa, we are not them! We simply appeared in your search due to that name being talked about on this particular web page. The phone number below will reach Roberts Hot Tubs, not the manufacturer of the brand of spa you're searching for. This is a public forum and you're more than welcome to post a question asking for contact or other information for a particular brand of spa. Almost certainly someone will be able to assist you.

(510) 234-7920

Register with our confidential mailing
list to receive notices of updates, special
offers and free information.

E-Mail address: 
subscribe unsubscribe