|Other Usefull Pages
[ BBS FAQ ] [ Error Codes ] [ Chlorine Info ] [ Bromine Info ] [ TDS ] [ pH Explained ] [ Electric Heater Guide ] [ Voltage Testing ] [ Pump Air Lock ] [ Owners Manuals ]
Drill a hole through the spa and install the light fitting. Typically the entire light assembly has a transformer that needs to be powered, and a built in switch of some kind (you need the built in switch). Then find a place to install the switch.
: I just got a quirky Weslo Daybreak 207 spa (essentially a clone of the
: Belize 2-person oval spa) and was bemused to find that it has no
: light installed -- no light, no switch, absolutely nothing.
: I see entire light kits online for spas for about $60 but not clear on
: how it would be powered. There is an open port on my power supply
: designated for an ozonator -- can I somehow tap into that?
: Any advice and/or suggestions on light kits to purchase would be really
: Also if anyone has suggestions on methods to drill the hole for the
: light and remove foam so the light has a good seating, that would be
: Thank you.
PLEASE NOTE: We are Roberts Hot Tubs Inc. (manufacturers of traditional wooden hot tubs)! If you found this webpage through a search engine while searching for a different brand of spa, we are not them! We simply appeared in your search due to that name being talked about on this particular web page. The phone number below will reach Roberts Hot Tubs, not the manufacturer of the brand of spa you're searching for. This is a public forum and you're more than welcome to post a question asking for contact or other information for a particular brand of spa. Almost certainly someone will be able to assist you.